Numark 5000FX, 5-Channel Scratch Mixer

EXTRAORDINARY FLEXIBILITY TO FUEL YOUR CREATIVITY

5000FX is a five–channel tabletop mixer that allows you to mix, affect, and control the most complex DJ situations. It harnesses the power of Numark's custom digital processing technology placing powerful effects and sampling at your fingertips.

This powerhouse mixer contains five channels with three phono, nine line, and two mic inputs. On the output side, 5000FX offers a pair of balanced XLRs plus Master, Record, Booth, and Zone RCA-pairs, and a digital 44.1 kHz S/PDIF out.

Two Beatkeeper™ units enable you to auto–detect BPM from two different sources with accuracy. Internal sampling gives you 30 seconds of memory to grab audio from any source. Multi–effects processing, smart, seamless looping, and BPM synchronization all give DJs superlative control and power over performances.

5000FX is, quite possibly, the most flexible DJ mixer ever created. With a wide range of inputs, built-in effects, sampling, dual Beatkeeper™, and more, 5000FX fuels your creativity.

Inputs:

• Line: 10Kohm input impedance; 83mV rms sensitivity for 1.22V output
• Mic: 600 ohm input impedance unbalanced; 1.9mv rms sensitivity for 1.22V output; 200mV rms max input
• Phono: 47Kohm input impedance; 1.3mV rms sensitivity @1KHz for 1.22V output

Outputs:

• Line: 6.5V rms max
• Headphone: 0.5W into 47 ohm
• Distortion: less than 0.01%

Signal to Noise Ratio (maximum output || JIS-A weighted):

• Line: Better than 82dB
• Mic: Better than 80dB
• Phono: Better than 72dB

Frequency Response:

• Line: 20Hz-20KHz ±0.5dB
• Mic: 20Hz-15KHz ±0.5dB
• Phono: ±1dB except for controlled attenuation of –3dB @ 20Hz to reduce rumble and feedback

Channel Equalizer:

• Bass: +6/-32dB @40Hz
• Middle: +6/-32dB @1.35KHz
• Treble: +6/-32dB @15KH
• Channel Kill: 80dB at 20Hz-20KHz

General:

• Power Consumption: 24 Watts typical; 29 Watts with full headphone output
• Dimensions (W x D x H): 320mm x 355mm x 100mm
• Weight: 6.1 kgs

Sampler:

• The maximum sample length is 36 seconds, total available buffer is 48 seconds, and buffer not used for sampler is used for echo, delay, scratch, reverse, and bleep effects.  The sampler will automatically stop recording once the record time exceeds 36 seconds.